PERMALEX® L Liquid Solvent Dye

PERMALEX® L Liquid Solvent Dye

Procedures:

Dyeing at 140º

Pre-scour with 1& STANSCOUR® BRC at 160º for 20-minutes.

  1. Drop & rinse.
  2. Set bath at 90ºF with:
    1. Xg/l salt (per chart below)
  3. Add PERMARBIL® Reactive Dye (pre-dissolve in 160º-180ºF water).
  4. Run 10-minutes.
  5. Add 1/10 total amount of Soda Ash over 10-minutes.
    1. Run 10-minutes.
  6. Add remaining 9/10 Soda Ash over 10-minutes (pH 10.8-11.2).
    1. Run 10-minutes.
  7. Heat to 140ºF at 2ºF/minute.
    1. Run for 45-minutes.
  8. Sample.
    1. If shade is acceptable, drop bath.
    2. When sampling shade, swatch should be: rinsed cold, rinsed warm, and neutralized with 0.25% Acetic Acid. Then, scoured at 200ºF – see steps 12-18.
  9. Rinse at 120ºF for 10-minutes.
    1. Drop bath.
  10. Rinse at 140º for 10-minutes.
    1. Drop bath.
  11. Neutralize at 120ºF with 0.25% Acetic Acid (pH 7-8).
    1. Run 10-minutes.
    2. Drop bath.
  12. Set fresh bath to 120ºF.
  13. Heat to 200ºF.
    1. Hold 10-minutes.
    2. Drop bath.
  14. Set bath to 120ºF.
    1. Hold 10-minutes.
    2. Drop bath.
  15. Finish as usual.

Salt and Soda Ash Recommendations for Cotton/Rayon

% Reactive Dye

g/l Sodium Chloride or Sodium Sulfate

g/l Soda Ash

0-0.25

30

5

0.26-0.50

50

5

0.51-1.00

60

10

1.01-2.00

60

10

2.01-3.00

80

10

3.01-5.00

80

10

Above 5.00*

*When dyeing above 5.00% the yield should increase with use of 100g/l salt

80-100

10

PERMABRIL® Brill Blue R Special Requires Reduced Salt

% Reactive Dye

g/l Sodium Chloride or Sodium Sulfate

up to 0.50

20

0.51-2.00

30

2.01-4.00

40

Above 4.00

50

Skip to content